autoBalance position

You can install the autoBalance on a flat surface or wall-mounted. Installing the dosing tubes

Place the autoBalance over the Sump or Aquarium level, so the lines inlets or outlets will remains under the autoBalance leves. This is to prevent backflow.

It is not recommended to place the autoBalance near strong electromagnetic sources such as recirculation pumps, power supplies, transformers, LEDs, sockets, etc. As they can affect the performance of the electronic components, especially the pH probe.

It must be protected from water and splashes.

An excessively humid environment can cause the equipment to rust and malfunction. Special care must be taken to ensure that the probe connector is dry and free of rust. If you observe excessive oscillations in the pH readings before it begins to pour reagent (swings of more than 0.15) clean and dry the probe connectors well.